ProSafe FAILSAFE 30amp Galvanic Isolator
ProSafe FS installs easily and does not require a dedicated monitor to verify the operational status of the galvanic isolator as required by non FailSafe Certified galvanic isolators.
- ProSafe FS 30 is built on robust FlatPack semiconductor platforms ensuring that in the event of a failure, the failure is safe by not compromising the ground continuity on-board when connected to AC Shore Power.
-
ABYC A-28 July '08 Compliant and Fail Safe Certified
Certified by Underwriters Laboratories (UL). Insures shore power safety ground wire is maintained through the isolator.
-
Flat Pack High Power Semiconductors
Robust high power diodes allow the FS Series to meet the new FailSafe criteria for conducting inrush currents of 3,000 amps for the required duration period.
-
Ignition Protected
Meets ISO 8846 and can be mounted within an engine compartment.
- Gold Plated Terminations
WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.
Owner's Manual (pdf)
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.